Entry 01 Signs & causes
Dacor trouble, read from the symptoms
Owners usually reach us with one of these complaints. The pairing on the right is where a technician starts looking, not a final answer.
-
Observed
Ticking carries on even with a steady flame burning
Probable cause
Moisture or spilled liquid around the switch or electrode, or a knob switch whose contacts have welded together
Repair page -
Observed
Burner clicks but never catches
Probable cause
Electrode coated in grime, burner cap riding high, or an ageing ignition module
-
Observed
Oven light comes on, cavity stays cool
Probable cause
Bake element burnt open, a gas glow-bar that has lost its strength, or a faulty sensor
-
Observed
Cakes rise lopsided or brown on one side
Probable cause
Convection fan not turning, element partly failed, or a range that is no longer level
-
Observed
Glass touch panel unresponsive, or chirping by itself
Probable cause
Moisture under the panel, a worn ribbon cable, or a control board fault
-
Observed
Induction zone switches off mid-simmer
Probable cause
Unsuitable pan, electronics overheating because the intake below is obstructed, or a failed board
-
Observed
Oven door will not unlock after a cleaning cycle
Probable cause
Latch motor or switch fault, or a control that has not registered the cool-down
Logged reply1 / 3
Why won't my Dacor igniter stop clicking?
Nonstop ticking usually means the spark circuit believes some knob is still turned to ignite. Liquid spilled around the knobs, a soaked electrode after cleaning, or a worn spark switch are the usual reasons. Let the top dry completely; if it persists after drying, a technician should meter the switches and module.