Entry 01 Procedure
Flame catches, then vanishes as the knob springs back
Of all Bertazzoni complaints, this one tops our list, and it is usually a small mechanical matter rather than a supply problem. Many Bertazzoni gas burners carry a flame-failure device: a slim thermocouple probe parked beside the flame that has to warm before the valve consents to stay open. With no odor of gas in the kitchen, walk through this once.
-
Begin with the knob at off
Rotate it all the way closed and wait briefly so any unburned gas drifts away before the next try.
-
Settle the cap on its crown
Lift off the cast cap, dry the crown underneath, and lower the cap so it rests flat and centered. One that wobbles or rides slightly askew throws a ragged flame that can miss the probe entirely.
-
Press, rotate, then hold
Push the knob in, turn to ignite, and after the flame shows keep pressing for several seconds more. That extra hold gives the thermocouple tip time to heat and latch the valve.
-
Ease off slowly
Let the knob return gradually. A flame that survives means the burner is fine and just wanted a longer hold. A flame that dies again means stop experimenting.
-
Log the culprit
Jot which position it sits in, whether the spark keeps ticking, and whether the flame burned blue or yellow. Dispatch can do more with that note than with anything else.
Gas smell: get out first
Gas smell: get out first
Notice even a faint gas odor and the relight attempt is over. Leave range knobs, wall switches, appliances and anything else that might spark exactly as they are. Walk everyone outside, put some distance between you and the house, and only then dial the gas utility or 911. The range itself can be booked for repair after that emergency is closed out.
- No relighting attempts while the odor is present
- No phone calls from inside the house
- No going back indoors until the utility or fire crew clears it