Entry 01 Table
What decides how hard the hood can pull
A hood is only one piece of a system. Airflow is the sum of the blower, every foot of duct, every turn, and what happens at the outside end. Where the ceiling soars and the roof cap is far off, each row below matters more than it would in a compact kitchen.
Table 1Factors that shape the draw of a Wolf hood
| Part of the system | How it cuts the draw | Who can check it |
|---|---|---|
| Baffle or mesh filters | Grease films over the openings and the blower spins against a closed door | You, by washing and reseating them |
| Blower motor and fan wheel | Worn bearings or a grease-heavy wheel turn slower and move less air at every speed | Technician |
| Length of the duct | Every extra stretch adds friction, so a long run to a distant roof cap loses pull before the air leaves | Technician, with access to the attic or chase |
| Elbows and transitions | Sharp turns and a duct that narrows on the way out choke the stream | Technician |
| Backdraft damper | A flap stuck half-closed by grease or salt corrosion blocks the exhaust | Technician; the outdoor end is not a ladder job for owners |
| Roof or wall cap | Debris, a nest or corrosion at the termination restricts the outlet | Visual check from the ground; repair by a technician |
| Replacement air | In a tightly closed house, the hood cannot pull out more air than can find its way back in | Opening a nearby window during heavy searing is a quick test |
| Ceiling height and canopy position | Smoke spreads sideways under a tall ceiling and escapes before the canopy captures it | Discussed at the visit; it shapes expectations more than repairs |